Gentlemen,
yesterday I started a call for help in this topic:
Viper TQS Calibration procedure
… but I feel uncomfortable in hijacking a thread.
Besides, it looks like it’s a new Viper TQS issue I have not seen before on the forum, so yes, I would like to open yet another thread.
The topic itself is well-known… it’s the idle detent… BUT:
I understand and appreciate the PRESS and RELEASE logic.
I understand the cutoff is not a part of the axis, but a seperate button (DX 18).
But I also assume that the very “trigger position” of DX 18 should be right on the CUTOFF position.
In my case, DX 18 is triggered on the IDLE position, of which I think is wrong.
Every time I pull the throttle back to idle, I can see
(in the launcher as well as in the device properties)
that DX 18 is fired… although I would it expect to be triggered inside the “off” zone.
My inquiry to the TM support is on its way.
For now, I would like to know
if my understanding is correct at all
if the position of DX 18 can be calibrated
if this is a hardware issue
if this is a firmware issue (I have 1.26)
if this is a driver issue (I have 1.2.3.0)
… anyway, if the nice looking device is going to be returned to sender or to be replaced.
Please let me know if somebody else has a familiar issue or a piece of advice what I could do to get the DX behind the detent.
Cheers everyone!
Positions.jpg
Button 18.jpg